Focus
Focus
Table of Contents

traceroute

Use the traceroute command to print the route taken by packets to a destination and to identify the route or measure packet transit delays across a network.

Command

traceroute interface dst-ipv4 (args=" ")

Options

dst-ipv4Enter the interface to listen on.
interfaceEnter the interface name or ID.
args= "-F"Use when probe packets should not be fragmented.
args= "-l"Displays the time-to-live (TTL) value of the returned packet.
args="-l"Use ICMP ECHO instead of UDP datagrams.
args="-m number"Enter the maximum number of hops (max TTL value) that trace route probe.
args= "-n"Print hop addresses numerically rather than symbolically.
args="-p string"This is the base UDP port number used in probes (default value is 33434).
args="-q number"Enter the number of probe packets per TTL. The default value is 3.
args= "-t number"Enter a value for Type of Service (TOS) in probe packets. The default value is 0.
args="-w number"Enter a time (in seconds) to wait for a response to a probe. The default value is 3 seconds.

Command Notes

RoleSuper, Read Only
Related Commands
Introduced inRelease 4.4.1

Example

traceroute 1 8.8.8.8 args="-n" traceroute to 8.8.8.8 (8.8.8.8), 30 hops max, 46 byte packets 1 200.30.0.2 92.231 ms 92.298 ms 92.241 ms 2 10.0.0.1 92.336 ms 92.327 ms 92.388 ms 3 66.128.148.171 93.410 ms 93.279 ms * 4 206.72.210.41 102.026 ms 102.013 ms 103.401 ms 5 108.170.247.225 101.901 ms * 108.170.247.161 101.729 ms 6 108.177.3.235 102.291 ms 72.14.232.197 102.165 ms 108.170.238.7 102.435 ms 7 8.8.8.8 101.937 ms 101.563 ms 102.023 ms