Install the PA-7080 Firewall EMI Filter
Table of Contents
Install the PA-7080 Firewall EMI Filter
Learn how to install the PA-7080 firewall EMI filter.
The PA-7080 Electromagnetic Interference (EMI)
filter (PAN-PA-7080-EMI-FLTR) reduces EMI emissions and is required
when you install the following hardware components:
If the last five digits of your PA-7080 firewall serial number are greater than 10,000, or the
PA-7080 was manufactured after March 2019, the built-in internal EMI filter is
already installed and this external EMI filter is not required. Inspect the back
vents to determine if the internal filter is installed.
- Slide the top tabs of the EMI filter into the top row of air vents on the back of the firewall and then lower the filter until it is flush with the chassis.
- Secure the filter to the chassis using the four captive
screws (two screws on each side).
![]()
